Still no Vista x64 compatibility?

from Stardock Forums
I see that the system requirements still explicitly state 32-bit only: "Windows XP (32-bit) or Vista (32-bit)". I'd just like to check if this still is correct, or if the system requirements just haven't been updated?
cursorfx
6,744 views 7 replies
Reply #1 from WinCustomize Forums Top
I am using CursorFX on my Vista Ultimate x64 machine with no problems.
Reply #2 from WinCustomize Forums Top
I am using CursorFX on my Vista Ultimate x64 machine with no problems.
End of quote


ditto!
Sins of a Solar Empire II
Reply #3 from Stardock Forums Top
How strange. I'd think that either x64 integration had been developed (in which case the system requirements should reflect the fact), or not, in which case it shouldn't work at all. I'm still a little concerned about unknown problems that could arise if it isn't really designed for Vista x64, but perhaps it is worth a try. Thanks for your replies :)
Reply #4 from WinCustomize Forums Top
Last I remember it was not fully suported for 64 bit. ( It may be supported now tho), But it is running well on my 64 bit vista. with no issues at all.
Reply #5 from WinCustomize Forums Top
but perhaps it is worth a try.
End of quote


Yes, definitely worth a try! I never use the default windows cursor anymore!
Reply #6 from Stardock Forums Top
it works on my vista x64, but it's still not problemfree.
major problems:

hotspot is displaced from actual cursorposition and is very tiny. You really need to pinpoint.

cursor gets 'sticky' without any direct reason. I.e. the cursor starts to move in starts and stops.
Reboot needed
Reply #7 from Stardock Forums Top

Its functional however I needed to set it to run in WindowsXP compatibility mode to get it to work. And it is a bit buggy at times. I don't use any of the mouse effects to lower the chances of problems with other applications.